Replacing The Lamp; Closing The Door; Technical Data - Electrolux SANTO 75338-2 DT Notice D'utilisation

Problem
There is too much frost.

Replacing the lamp

CAUTION!
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Pull outwards the rear hook of the lamp
cover by using a screwdriver and remove
the lamp cover pulling downwards.
3. Replace the lamp with one of the same
power (the maximum power is shown on
the lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light
comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

Technical data

Dimension of the recess
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Possible cause
Food is not wrapped correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not
set correctly.
Height
Width
Depth
Technical data
Solution
Wrap the food correctly.
Set a higher temperature.
1750 mm
600 mm
645 mm
20 h
31