Closing The Door; Installation - Electrolux TG09210 Notice D'utilisation

Problem
Green indicator
flashing

8.1 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

9. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor (garage or cellar) al-
so, but for optimum performance install
this appliance at a location where the am-
bient temperature corresponds to the cli-
9.2 Levelling
Possible cause
There is no voltage in the
mains socket (try to con-
nect another appliance in-
to it)
The appliance is not
switched on
Temperature Regulator is
not on
Temperature sensor prob-
lem
3.
mate class indicated on the rating plate of
the appliance:
Cli-
mate
class
SN
N
ST
T
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.
Solution
Call an electrician
Switch on the appliance
Check the Temperature
Regulator
Call the service personnel
If necessary, replace the defective
door gaskets. Contact the Service
Center.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
ENGLISH 61