Corsair HS65 Mode D'emploi page 3

RF WIRELESS MODE
PC - Connect the wireless USB receiver to any USB (type-A) port on your PC. Press the power button on the
headset. The headset powers on in RF wireless mode by default. The headset is designed to operate at a range of
up to 50 feet (15.24m) from the receiver, but other wireless devices, electronics and obstructions such as walls may
impact performance.
Note: The first time you use the CORSAIR HS65 WIRELESS headset on a PC, the operating system will
automatically install a device driver. After the device driver is installed, we recommend you reboot your PC
before use.
PLAYSTATION - Connect the wireless USB receiver to any USB (type-A) port on your PS5 or PS4 console. Use the
PlayStation settings menu to set "Output to Headphones" to "All Audio" and adjust volume control (Headphones) to
maximum level. Then adjust volume with the headset volume control.
iCUE
Go to corsair.com/support/downloads to download the CORSAIR iCUE software. Using iCUE software will enable
the full feature set of the HS65 WIRELESS headset. The USB Wireless Receiver must be connected to your PC to
use iCUE software.
Note: If the headset is used without software, some features will be disabled.
> Install the iCUE software on a PC running Windows 10 or later, or on macOS.
> After installation is complete, reboot your PC, and launch iCUE.
iCUE SOFTWARE CAN BE USED TO:
> Select and customize audio equalizer (EQ) settings.
> Set Dolby Audio 7.1 surround sound on or off.
> Enable SoundID™ audio personalization. Requires USB Wireless Receiver to enable.
(Not available with Bluetooth)
The software's built-in documentation explains how to use the HS65 WIRELESS's features in greater detail.
BLUETOOTH MODE
With the headset powered on, enable pairing by holding the MFB until the status LED rapid blinks red and blue.
When the headset is paired, the status LED will blink blue. Quick press the power button to toggle between RF
wireless and Bluetooth modes. When the headset is in RF wireless mode the status LED will blink red, orange
or green depending on the current battery level. Note when the headset is in RF wireless mode and paired via
Bluetooth with a mobile phone, it will only accept and receive phone calls. Quick press the power button to enter
Bluetooth mode and enable both phone calls and Bluetooth audio (such as when listening to music). The headset
will default to the last mode it was set to when turned off.
ANSWERING AND ENDING PHONE CALLS
To answer an incoming call, single press the MFB. To end the call, single press the MFB again.
ENGLISH
2