Fuse Replacement - Emerson Appleton Baymaster Serie Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WIRING DIAGRAM - LED CIRCUIT WITH SPD
WIRING DIAGRAM - LED CIRCUIT WITH FUSE AND SPD

Fuse Replacement

• Replace only with a fuse rating (ampere and volts) as specified on the fuse label (located inside the luminaire housing).
• The replacement fuse must be non-arcing (filled), non-indicating, and current limiting.
• The fuse is for supplementary protection only.
Except as expressly provided by Appleton Grp, LLC (Appleton), Appleton products are intended for ultimate purchase by industrial users and for operation by persons trained and experienced in the use and maintenance of this equipment
and not for consumers or consumer use. Appleton warranties DO NOT extend to, and no reseller is authorized to extend Appleton's warranties to any consumer.
While every precaution has been taken to ensure accuracy and completeness in this manual, Appleton Grp, LLC. assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or
omissions. Specifications are subject to change without notice. The Appleton and Emerson logos are registered in the U.S. Patent and Trademark Office. All other product or service names are the property of their registered owners.
©2017 Appleton Grp, LLC. All rights reserved.
650526-001 Rev. D 05/17/17 • Page 6 of 12

Publicité

Table des Matières
loading

Table des Matières