Luminaire Assembly To Pendant Hood - Emerson Appleton Baymaster Serie Instructions D'installation

Wiring of Pendant Hood
WARNING: The luminaire must be grounded as required by the National Electrical Code (Paragraph 410-21 and Article 250) or
Canadian Electrical Code (Rule 30-500 and Section 10). Verify that ground continuity has been established by using an Ohm meter
or other suitable testing equipment before energizing the luminaire. Failure to properly ground the luminaire will create an electric
shock hazard, which can cause serious injury or death.
Wiring the Baymaster LED Luminaire
1. Remove terminal block from pendant hood by loosening the two mounting screws as shown in Figure C..
2. Connect the threaded pendant hood onto the conduit and tighten the locking set screw to the conduit.
3. Connect the ground wire to the green grounding screw provided in the pendant hood.
4. Connect supply wires to the terminal block.
5. Reinstall the terminal block in the pendant hood and tighten down the two mounting screws.
Figure 2: Pendant Hood Wiring

Luminaire Assembly to Pendant Hood

1. Switch off the power to the pendant hood.
2. Align the arrows of the adaptor and pendant hood as shown in Figure 3 (F) below.
3. Push the luminaire in the direction of the arrow as shown in Figure 3 (E).
4. Rotate the luminaire in the direction of the arrow (counter-clockwise) as shown in Figure 3 (G) until you feel it snap and click into
place. The arrows on the pendant hood and adaptor will align as in Figure 3 (H).
5. Tighten the locking set screw with a torque of 37 in-lbs.
6. Power can now be applied to the luminaire.
Figure 3: Installation of Luminaire to Pendant Hood
Appleton • 1.800.621.1506 • www.appletonelec.com 650526-001 Rev. D 05/17/17 • Page 3 of 12