Fuse Replacement - Emerson Appleton Industrial Areamaster Mode D'emploi

Table des Matières

Publicité

Figure 15: Wiring Diagrams

Fuse Replacement

• Replace only with a fuse rating (ampere and volts) as specified on the fuse label (located inside the luminaire housing).
• The replacement fuse must be non-arcing (filled), non-indicating, and current limiting.
• The fuse is for supplementary protection only.
Except as expressly provided by Appleton Grp, LLC (Appleton), Appleton products are intended for ultimate purchase by industrial users and for operation by persons trained and experienced in the use and maintenance of this equipment
and not for consumers or consumer use. Appleton warranties DO NOT extend to, and no reseller is authorized to extend Appleton's warranties to any consumer.
While every precaution has been taken to ensure accuracy and completeness in this manual, Appleton Grp, LLC. assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or
omissions. Specifications are subject to change without notice. The Appleton and Emerson logos are registered in the U.S. Patent and Trademark Office. All other product or service names are the property of their registered owners.
©2016 Appleton Grp, LLC. All rights reserved.
650544-000 Rev. A 12/16 • Page 11 of 12

Publicité

Table des Matières
loading

Table des Matières