Klarfit 10006711 Mode D'emploi page 20

Step 2
1. Pull the tension wire (14) through the handlebar post (11) and take it out from the front
tension hole of the post; then connect the extension wire (13) with sensor wire (12),
insert the handlebar post (11) onto main frame (1) and lock it tightly with arc washers
(5) and screws (18).
2. Connect the tension controller (15) with tension wire (14), then lock the tension con-
troller (15) on the handlebar post (11) tightly with flat washers (16)and screws (17).
Important note: Protect the cable inside from damage when completing this step.
20