Event List; Hdd Management - LUXSAR VDR410 Manuel Utilisateur

Press ▲ or ▼ key on "EVENT LIST" & ◄ or ► to enter: Use the ◄ or ► button to select items. Press
the ▲ or ▼ button to confirm the selection.
Press MENU back to SETUP MENU.
Use "▲ or ▼" key to select event which needs to be played，location of " > " symbol will move up
and down for indicating current event which been selected.
Press "◄ or ►" key to select events storage from master hard drive or slave hard drive. When
once selection has been made and than press ►PLAY key to start playback.
There are totally 3 different type's event will be recorded:
1. RECORD：Event starts recording by press "REC" key.
2. POWER：When power off or loss, system would add this issue, and "POWER ERROR DETECTED"
would show on screen while boot.
3. MOT CH1：When motion detection was triggered, event up with alarm number.
Record setup "MOTION EVENT MIGRATION" must at ON.
In the period of alarm record triggered constantly that the a single EVENT LIST
item will be extend while lapsed, thus ENET LIST would show the first triggered
channel number on the list and the recording seconds will be extended .

3.8. HDD Management

HDD MANAGEMENT
OVERWRITE ENABLE
HDD FULL WARNING
HDD CAPACITY 76GB
HDD LEFT RATIO
HDD FORMAT N/A
EXIT
Press ▲ or ▼ key on "NETWORK SETUP" & ◄ or ► to enter: Use the ◄ or ► button to select items.
Press the ▲ or ▼ button to confirm the selection.
Press MENU back to SETUP MENU.
OVERWRITE MODE
Use "◄ or ►" button to enable or disable overwriting when HDD is full. When HDD overwrite is
enabled, the oldest partition on HDD will automatically be reused, and the oldest images will be
overwritten the current images. When overwrite mode is disabled, the HDD Full Warning
percentage selection will be appeared and need to be configured.
YES
10%
73GB 97%
YES (YES/NO)
12