Record Setup - LUXSAR VDR410 Manuel Utilisateur

HUE
Use ◄ or ► button to adjust the hue of the selected camera. Initial number is 5 (STANDARD).

3.4. Record setup

RECORD SETUP
RECORD MODE
NORMAL RECORD FPS
ALARM RECORD FPS
ALARM RECORD DWELL 10SEC
RECORD QUALITY
MOTION MIGRATION ON
EXIT
Press ▲ or ▼ key on "RECORD SETUP" & ◄ or ► to enter: Use the ▲ or ▼ button to select items.
Press the ◄ or ► button to confirm the selection.
Press MENU back to SETUP MENU.
RECORD MODE
Use ◄ or ► button to select MUX (multiplexer) or OD (QUAD) recording.
NORMAL RECORD FPS
Use ◄ or ► button to select recording speed. 15P means 15 fields per second, 30P is the highest
speed, and 1P is the lowest. There are 1 / 2 / 3 / 4 / 5 / 7 / 10 / 15 & 30 you can choose, NTSC
default 15P, PAL at 12P.
ALARM RECORD FPS
Use ◄ or ► button to select alarm recording speed when external alarm or motion detection is
triggered. There are 1 / 2 / 3 / 4 / 5 / 7 / 10 / 15 & 30 you can choose, NTSC default 30P, PAL at
25P.
ALARM RECORD DWELL
Use ◄ or ► button to set the dwell time for alarm recording when motion detection is triggered.
There are a total of 30 speeds you can choose from 1 to 30. When Motion is triggered and within
the dwell period: the screen will be switched into quad mode. The corresponding camera will be
marked ID "MOT", default 10 seconds.
MUX
30P
30P
HIGH
1/2/3/4/STANDARD/6/7/8/9/10
MUX/QUAD
1/2/3/4/5/7/10/15 & 30P
1/2/3/4/5/7/10/15 & 30P
1~30SEC
9