Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.3.
Turn the bottom of the DVR up and make 4 screws on as follows. Screws are inside the
accessory kit.
8.4.
After HDD installed and the power connected well, turn on the DVR. Then, OSD will
display HDD information. After confirmation, screw on the cover of the DVR.
Attentions：
1. Hard drive master mode must be set correctly.
2. Make sure power cable is unplugged before hard drive installation starts.
3. IDE cable and power cable must be hooking up correctly.
4. HDD cool down is based on the DVR case, so please make sure the HDD is
installed well.
27
VDR410_Manuel_En_V02
Publicité
Table des Matières
