LUXSAR VDR410 Manuel Utilisateur page 45

5. PLAYBACK FROM USB
5.1. Introduction & system requirement
• Introduction
Form YAViewer4 software will show the stream image stored in the HDD which was
previously formatted and recorded from DVR via USB cable.
When DVR connected to PC, DVR would stop to recording and "USB ►►► PC" will
show on the DVR screen for HDD data transmission, after unplug the USB connector DVR
would boot up automatically.
The YAViewer4 will automatically detect the HDD and show the recorded stream. You
can also save the current screen to a BMP file, and save the current stream to a stream
file [the file extension for the stream file is "MYS"].
The YAViewer4 consists of two functional modules:
View & Backup
MYS File Player
• System requirement
System Recommendation
Microsoft Windows 2000 or Later (XP, 2003).
CPU 1.0 GHz or Higher.
RAM 256 MByte or greater.
DirectX 7.0 or later.
• Hardware Installation
With the USB cable link DVR and USB port on PC.
DVR would switch into "USB to PC" mode, after disconnection system would reboot
automatically.
PC would detect new HDD added, if your operation system require initialing the new
detect DVR hard disk, please cancel this initial action!! , all of data will erase if been
initialed.
As stated above, the application shows stream which is stored in HDD from DVR. Before
installing and executing the application, make sure that you connected HDD to the IDE
cable of your PC directly, or via USB HDD adaptor.
• Software Installation
Make sure that the OS of your PC is Windows 2000 or above. Otherwise, the application
will not operate properly.
The application is just one execution file. Please copy from DVR CD disk to any directory
you want.
Shows stream stored in the HDD directly.
Plays captured stream file.
18