LUXSAR VDR410 Manuel Utilisateur page 37

RECORD QUALIT
Use ◄ or ► button to select the BEST, HIGH, MEDIUM or LOW recording quality that can be
chosen from. The amount of storage will be consumed with higher quality. Thus, this setting
should be carefully chosen for hard disk volume. A table at cheap 6 for relationship between
quality, recording speed and hard disks for reference.
MOTION MIGRATION
Use ◄ or ► button to select add detected motion into event list or not, and the default setting is
on.
3.5. Alarm setup
ALARM SETUP
BUZZER DWELL
VIDEO LOSS ALARM
MOTION ALARM
ALARM DISPLAY MODE
EXIT
Press ▲ or ▼ key on "ALARM SETUP" & ◄ or ► to enter: Use the ▲ or ▼ button to select items.
Press the ◄ or ► button to confirm the selection.
Press MENU to go back to SETUP MENU.
BUZZER DWELL
Use ◄ or ► button to set the dwell time for buzzer issue occur. There are a total of 31 periods you
can choose from 1 to 30 seconds or "CONT" for constantly.
VIDEO LOSS ALARM ON/OFF
Use ◄ or ► button to select video loss alarm function on or off.
MOTION ALARM
Use ◄ or ► button to switch function on or off when motion occur.
ALARM DISPLAY MODE
During recording & full channel mode, if ALARM DISPLAY MODE is ON, system would switch
to the ALARM or MOTION channel and the period depend on
5SEC
ON
OFF
OFF
1/2/3 to 30 SEC & CONT
ON/OFF
ON/FF
BEST/HIGH/MEDIUM/LOW
ON
ALARM RECORD DWELL.
10