Radio; Storing And Receiving Stations; Storing Automatically - Btm; Storing Manually - Sony DSX-S300BTX Mode D'emploi

Radio

Storing and receiving stations

Caution
When tuning in stations while driving, use Best
Tuning Memory (BTM) to prevent an accident.
Storing automatically — BTM
1
Press (SOURCE/OFF) repeatedly until
"TUNER" appears.
To change the band, press (MODE)
repeatedly. You can select from FM1, FM2,
FM3, MW or LW.
2
Press and hold the multi way encoder.
3
Rotate the multi way encoder to select
"BTM," then press it.
The unit stores stations in order of frequency
in the preset list.
A beep sounds when the setting is stored.

Storing manually

1
While receiving the station that you
want to store, press
The preset list appears.
2
Push the multi way encoder up/down
to select the preset number.
3
Press and hold the multi way encoder
until "MEM" appears.
(with the card remote commander)
1
While receiving the station that you
want to store, press and hold a
number button ((1) to (6)) until
"MEM" appears.
Note
If you try to store another station on the same number
button, the previously stored station will be replaced.
18
(BROWSE).

Receiving the stored stations

You can list up the frequency.
1
Select the band, then press
(BROWSE).
The preset list appears.
2
Push the multi way encoder up/down
to select the desired station.
3
Press the multi way encoder to receive
the station.
The display returns to normal reception
mode.
(with the card remote commander)
1
Select the band, then press a number
button ((1) to (6)).

Tuning automatically

1
Select the band, then push the multi
way encoder left/right to search for the
station.
Scanning stops when the unit receives a
station. Repeat this procedure until the
desired station is received.
Tip
If you know the frequency of the station you want to
listen to, push and hold the multi way encoder left/right
to quickly locate the approximate frequency, then push
the multi way encoder left/right repeatedly to fine
adjust to the desired frequency (manual tuning).