Soundcore Liberty Air 2 Mode D'emploi page 4

• Earbuds firmware update: The earbuds firmware can be updated in the App. You will be informed
once the new version of firmware is detected when you connect the earbuds with the App.
Download the Soundcore App for HearID,
UI customization and EQ settings.
Soundcore
Google Play and the Google Play logo are
trademarks of Google Inc.
Reset
Reset the earbuds if the earbuds cannot connect with each other properly or cannot connect
with your device properly.
1. Place the earbuds into the charging case and make sure they are being charged.
2. Keep the charging case open, then press and hold the button on the bottom of the charging
case for 10 seconds until the LED indicators on both earbuds flash red 3 times.
All the memory data will be cleared.
05 EN
Apple and the Apple logo are trademarks
of Apple Inc.
3
10"
Specifications
Specifications are subject to change without notice.
Input
Rated output power
Battery capacity
Charging time
Playtime
(varies by volume level and content)
Driver size
Frequency response
Impedance
Bluetooth version
Bluetooth frequency
Bluetooth range
Qualcomm®aptX ™ Technical specifications
Compression ratio: 4:1
Word Depth: Support 16 bit and 24bit
Decoding delay: Sample Rate 48kHZ<2ms
Dynamic range: 16bit>92dB, 24bit>120dB
Data rates: 352kbps
Decode mode: Stereo
Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its subsidiaries.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and
other countries. aptX is a trademark of Qualcomm Technologies International Ltd., registered
in the United States and other countries.
5 V 500 mA
5 mW @ 1% THD
55 mA x 2 (earbuds); 500 mA (charging case)
1.5 hours (for earbuds); 2 hours (for charging case
via USB); 3.5 hours (for charging case via wireless
charger)
7 hours (Totally 28 hours with the charging case)
6 mm diamond coated driver x 2
20 Hz - 20 kHz
16 Ω
V 5.0
2402-2480 MHz
10 m / 33 ft
EN 06