Hkoenig naty210 Manuel D'instructions page 12

Press the cleaning button again to select the intensive
cleaning mode. This program takes 8 minutes. It is
recommended to run the intensive cleaning program
regularly, even if the appliance is in constant use. Add a
drop of mild detergent into the mixing chamber before
the program starts. On first use, make sure that the
detergent is not too highly concentrated to prevent
excessive foam from forming in the mixing chamber. If
foam residues remain after the end of the program, flush
out the appliance using the 3-minute flushing program.
After the end of the self-cleaning process, open the lid to
allow the mixing chamber to dry.
3. Open the lid and simply remove it in the vertical
direction for easier cleaning by hand. You can also
simply remove the plug. Do not clean the lid and plug in
dishwasher, to avoid damaging the seals.
4. Also regularly clean the metal pins protruding into the
mixing chamber, the silicone valve through which the
water flows into the mixing chamber, as well as the
silicone spout with a damp cloth.
5. Regularly clean the water container to make sure it
always stays hygienically clean.
6. Clean the housing with a damp and soft cloth and
thoroughly dry afterwards.
Tips: should the blades be stained by ingredient, pour
some water into the mixing chamber and add a denture