Preparing The Generator; Wheel Installation - Power Fist 4650 Mode D'emploi

V1.0
L. Engine Switch
M. Circuit Breakers
N. Reset Button
O. Oil Alert Indicator
ASSEMBLY & INSTALLATION

PREPARING THE GENERATOR

The generator requires little preparation for use once out of the box.
However, before attempting to start the generator, be sure it is ready.
1. Inspect the generator and remove any packaging inside the frame.
2. Make sure spark plug, muffler, fuel cap and air filter are in place
and secured.
3. Make sure the spark plug lead is securely connected to the spark
plug, otherwise unintentional sparking can result, causing a fire or
an electric shock.

WHEEL INSTALLATION

1. Push the axle bolt through the wheel.
2. Push the axle bolt through the hole on the frame.
3. Push the R-pin through the hole in the axle bolt to secure it.
Page 7
GASOLINE GENERATOR
P. Volt Meter
Q. DC Reset Button
R. DC 12V Outlet
S. AC 120/240V
Outlet
T.
U. Ground Bolt
V.
www.princessauto.com / 1-800-665-8685
8962235
Voltage Selector
AC 120V