Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
The spark plug must be properly gapped and free of deposits for the
best performance. Check local bylaws to see if a resistor spark plug is
required to suppress ignition signals. Replace the included spark plug
with a resistor spark plug if required.
1.
Remove any dirt from around the spark plug area.
2.
Unclip the spark plug lead and remove the spark plug with a spark
plug wrench. This will have a rubber pad inside the socket to
protect the spark plug's ceramic coating.
3.
Inspect the spark plug. Replace it if damaged, badly fouled, the
sealing washer is in poor condition or the electrode is worn.
4.
Check the gap with a spark plug gauge. If
necessary, reset the gap (See Specifications).
5.
Correct the gap by carefully bending the side
electrode. Check the gap after each adjustment.
6.
Install the spark plug by hand, to avoid cross
threading, until the gasket is compressed. Tighten
an additional 1/2 to 1/3 turn more with a spark plug
wrench or to the recommended torque if listed in
the Specifications.
7.
Reconnect the spark plug lead to the spark plug.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws
for electronic devices, batteries, oil or other toxic liquids.
DO NOT pollute the environment by allowing uncontrolled discharge of
waste oil.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
Page 19
GASOLINE GENERATOR
www.princessauto.com / 1-800-665-8685
8962235
Fig. 5
Publicité
Table des Matières
