Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8962235
EMISSION CONTROL SYSTEM INFORMATION
The combustion process produces carbon monoxide, hydrocarbons
and nitrogen oxides. Controlling these emissions is important for
personal and environmental health.
The following instructions must be followed in order to keep the
emissions from your engine within Canadian emission standards.
1.
Do not remove or alter any part of the intake, fuel or exhaust
system.
2.
Do not alter or bypass the governor linkage or a speed-adjusting
mechanism that force the engine to operate outside its design
specifications.
PROBLEMS THAT MAY AFFECT EMISSIONS
Have your engine inspected and repaired by a qualified technician if
you are aware of any of the following symptoms.
1.
Hard starting or stalling after starting.
2.
Rough idle.
3.
Misfiring or backfiring under load.
4.
Afterburning (backfiring).
5.
Black exhaust smoke or high fuel consumption.
REPLACEMENT PARTS
The emission control systems on the engine is designed, built and
certified to conform to Canadian emission regulations. Genuine parts
are recommended when servicing the engine. Genuine replacement
parts are manufactured to the same standards as the original parts.
Using replacement parts that are not of the original design and quality
may impair the effectiveness of the emission control system.
It is the responsibility of the aftermarket part manufacturer to certify
that the part will not result in a failure of the engine to comply with
emission regulations.
REPLACING THE SPARK PLUG
NOTICE! Using an incorrect spark plug can cause engine damage. Only
replace a spark plug with a model recommended by the manufacturer.
www.princessauto.com / 1-800-665-8685
GASOLINE GENERATOR
V1.0
Page 18
Publicité
Table des Matières
