Cleaning The Sediment Cup - Power Fist 4650 Mode D'emploi

V1.0
NOTICE! When the carburetor has been modified for high altitude
operation, the air fuel mixture will be too lean for low altitude use.
Operation at altitudes below 5,000 ft (1,524 m) may cause the engine to
overheat and result in serious engine damage. When using this engine at
low altitudes, have a qualified technician return the carburetor to
original factory specifications.

CLEANING THE SEDIMENT CUP

CAUTION! Wear latex or rubber gloves when working on the sediment
cup. The cup may contain fuel that will cause skin irritation. Prolonged
and repeated exposure to fuel on skin may result in dry, cracked skin.
1. Switch the fuel valve to the OFF position.
2. Remove the fuel sediment cup, screw and o-ring.
3. Clean the sediment cup with a non-flammable solvent
or detergent and rinse. Allow to dry. Some chemicals
will damage the o-ring material. Check for compatibility
or replace the o-ring.
4. Reassemble the sediment cup and o-ring.
5. Switch the fuel valve to the ON position and check for
leaks. Replace the o-ring if the installation is correct,
but fuel still leaks from the cup.
ADJUSTING THE ENGINE IDLE SETTING
NOTICE! The engine speed is set by the factory. Increasing the speed too
much can damage the engine. Too low a speed will reduce the engine' s
efficiency. Have a qualified technician adjust the engine speed if
necessary.
The engine's idling speed is adjustable by turning the governor arm
screw to lower or increase the engine output (RPMs).
1. Remove the shroud and locate the governor arm screw.
2. Start the engine and wait for it to idle.
3. Tighten the screw to increase the engine speed. Loosen to reduce
speed.
4. Shut the engine off and allow to cool
Page 17
GASOLINE GENERATOR
www.princessauto.com / 1-800-665-8685
8962235
Fig. 4