Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8962235
4.
SAE 10W-30 is recommended for
general, all-temperature use. Other viscosities shown on the chart
may be used when the average temperature in your area is within
the indicated range.
5.
Using 10W-30 oil when the temperature is above 27°C (80°F) may
increase oil consumption . Check the oil level more often.
6.
Starting the engine will be more difficult when using SAE 30 oil
below 4°C (40°F).
HOW TO CHECK OIL
1.
Level the engine or the equipment the engine is mounted on.
2.
Clean the oil fill area of any dirt and debris to prevent
contamination that can damage the engine.
3.
The engine has a dipstick that is either
part of the oil fill plug or a separate
component (see Parts Identification).
a.
Remove the dipstick and wipe with a
clean cloth.
b.
Reinsert the dipstick into the filler
neck until it rests on the opening's
rim. Do not screw the oil fill plug back into the opening.
c.
Remove the dipstick and check that the oil is between the Full
and Fill marks. Add or drain oil based on the measurement
d.
Reinsert the dipstick and either press firmly to hold in place or
screw the oil fill cap hand tight.
HOW TO ADD OIL
IMPORTANT! Read the Engine Oil section before adding oil to ensure that
it is suitable for the engine.
1.
Remove the oil filler cap and place to one side.
2.
Place a funnel into the oil fill neck. The funnel opening should be
wide enough to prevent the oil from collecting in the funnel's cone.
3.
Pour oil into the funnel. Allow the oil to settle for one minute and
recheck the level. Repeat until the desired level is reached.
4.
Insert the oil filler cap and hand tighten.
www.princessauto.com / 1-800-665-8685
GASOLINE GENERATOR
Fig. 2
V1.0
Fig. 1
Page 14
Publicité
Table des Matières
