Low Oil Shutdown; Starting The Engine - Power Fist 4650 Mode D'emploi

V1.0

LOW OIL SHUTDOWN

The oil alert system is designed to prevent engine damage caused by
an insufficient amount of oil in the crankcase. Before the oil level in the
crankcase can fall below a safe limit, the oil alert system will
automatically stop the engine (the engine switch will remain in the ON
position). The oil alert system should not take the place of checking the
oil level before each use. If the engine stops and will not restart, check
the engine oil level before troubleshooting in other areas.

STARTING THE ENGINE

WARNING! Direct-coupled equipment components such as, but not
limited to, blades, impellers, pulleys, sprockets, etc., must be securely
attached before the engine is started to avoid injury or damage.
1. Move the fuel valve to the ON position.
2. Move the choke level to the CLOSED position if the engine is cold.
The choke is unnecessary when restarting a warm engine.
3. Move the throttle lever away from MIN. position, about 1/3 of way
toward the MAX. position.
4. Turn the engine switch to the ON position
5. Pull the starter handle lightly until you feel resistance, then pull the
starter handle briskly. The engine should turn over and start
running.
Do not allow the starter handle to snap back against the engine.
Instead, return the starter grip gently by hand.
6. If the engine floods, set the choke to the OPEN/RUN position,
place the throttle in FAST and attempt to start the engine again.
7. If the choke lever was moved to the CLOSED position to start the
engine, gradually move it to the OPEN position as the engine
warms up.
The engine may make a metallic rapping noise (spark knock, ping)
while running under a heavy load. This is normal. Replace the fuel with
premium quality gasoline if the metallic rapping noise continues under
normal load. Contact a qualified mechanic if the pinging continues as
this may indicate existing engine damage.
Page 9
GASOLINE GENERATOR
www.princessauto.com / 1-800-665-8685
8962235