Assembly Instructions - DESKY DUAL MINI Guide D'utilisation

Step 1
Place the two Crossbar ends (A) upside down so that the eight (8) machine grub
screw holes (G) are facing upward as pictured.
The Crossbar rails (B) are located inside the Crossbar ends (A) and will need to be
removed and set aside for later steps.
A
Step 2
J
A
B
Place the Crossbar end (A) upside down as
pictured and insert the leg (J) so that the
four (4) holes in the leg line up with the 4
holes on the crossbar end.
Ensure that the Crossbar end is orientated
so that the machine grub screws (G) face
upward when inserting the leg.
Insert four (4) Machine screws (F) and use
the Hex key (E) to scew in a few turns. Do
G
not tighten completely.
Repeat this step for the second leg.
F
ASSEMBLY
INSTRUCTIONS
G
9