DESKY DUAL MINI Guide D'utilisation page 20

Calibrating Display Height
At its lowest position the desk sits at a height of 60cm from the ground to the top
of
the desk frame (underside of the desktop). If the controller display does not show
this height the controller can be calibrated.
To calibrate display height:
1. Press and hold the DOWN button until the desk reaches its lowest position.
2. Press and hold the DOWN button again for 10 seconds until the display
reads 'RST'.
3. Press and hold the 'M' button for 5 seconds until the display shows the
number programmed as the lowest height.
4. Press the UP or DOWN buttons to adjust the height on the display to read
'60'.
5. Wait for the display to read 'RST' again.
6. Press and hold the DOWN button again until the desk lowers a little bit
more and then slightly rises. Release the DOWN button, the desk will display
the height and is now ready to use.
Changing Anti-Collision Sensitivity
You may wish to alter the anti-collision sensitivity if you find the anti-collision
system is engaging accidentally or you want to increase the sensitivity which the
Anti Collision Sensitivity:
1. Press and hold the DOWN button until the desk reaches its lowest position.
2. Press and hold the DOWN button again for 10 seconds until the display
reads 'RST'.
3. Press and hold the 'UP' button for 5 seconds while the LED flashes 'RST' and
then switches to either:
10.5 = Most Sensitive (10kg pressure)
10.6 = Mid Sensitivity (15kg pressure)
10.7 = Least Sensitive (20kg pressure)
4. Release the 'UP' button. Press and Hold the 'UP' button again until the de-
sired setting is reached. Once the chosen setting is displayed, release the
button and wait about 5 seconds for the display to return to 'RST'.
5. Finish the reset process by pressing and holding the 'DOWN' button until the
desk lowers and rises slightly and then stops
PROGRAMMING
CONTROLLER
20