DESKY DUAL MINI Guide D'utilisation page 10

Step 3
C
F
Step 4
J
Position the Side bracket (C) against the
back of the Crossbar end (A) so that the
four (4) holes in the sie bracket line up with
the holes on the crossbar end.
A Insert four (4) Machine screws (F) and use
the large Hex key (E) to screw in a few turns.
Do not tighten completely. Start with the
two outside screws first.
Repeat this step for the second leg.
Now tighten all the Machine screws (F)
from Steps 2 and 3.
F
Place the Foot (D) onto the leg (J) as shown
so that the four holes in each line up.
Insert four (4) Machine screws (F) and use
the large Hex key (E) to screw in a few turns.
Once all four screws have been started,
tighten completely.
D
Repeat this step for the second foot.
Round levelling feet/ studs are attached to
each foot to assist with levelling the desk.
ASSEMBLY
INSTRUCTIONS
10