Depth Adjustment - Makita DST221 Manuel D'instruction

014793
To secure the sub magazine in place, hook the locking
lever on the rear of the sub-magazine.
CAUTION:
With the magazine loaded, if the tool is held
•
downward and the sub-magazine is opened, the
staples can fall out and present a danger to
anyone or anything below. Keep this in mind
especially when working in high locations.
Unloading staples
CAUTION:
When removing staples, make sure that your fingers
•
are not placed on the trigger or the lever and the
battery cartridge is removed from the stapler. Misfiring
may cause personal injuries and property damage.
Remove the battery cartridge.
Press the locking lever and slide the magazine back.
2
014792
Take out staples from the magazine slit.
014798
Hook
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger or the lever and the battery cartridge
is removed before using the hook.
1. Staples
1
2. Main magazine
2
1. Sub magazine
1
2. Locking lever
1. Sub magazine
1
2. Locking lever
2
1
014795
CAUTION:
Do not hang the hook from the waist belt.
•
Dropping the stapler, which is caused by the hook
accidentally coming out of place, may cause
misfiring and personal injuries.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
014794
OPERATION

Depth adjustment

009163
If the staples are driven too deep or too shallow, adjust
the driving depth by turning the nut on the bottom of the
tool. For deeper driving of staples, turn the nut
clockwise. For shallower
counterclockwise. Please note the nut must be turned in
increments of 90° (1/4 turn) so that the groove on the
nut runs parallel to the magazine.
7
1. Groove
2. Hook
3. Screw
2
3
1. Nut
1
driving, turn the nut