Safety System; Loading Staples - Makita DST221 Manuel D'instruction

Indicating the remaining battery capacity
(Only for battery cartridges with "B" at the end of the
model number.)
2
015676
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
Indicator lamps
Lighted Off
015658
NOTE:
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.

Safety system

1
014791
1. Indicator lamps
2. CHECK button
1
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
1. Trigger
2. Safety lever
2
Make sure all safety systems are in working order
before operation. The tool must not operate if only the
switch trigger is pulled or if only the safety lever is
pressed against the wood. It must work only when both
actions are performed. Test for possible faulty operation
with a tool unloaded and pointed well away from
yourself or any bystanders.
NOTE:
There is a possibility that the tool may operate for
•
an instant when only the trigger is pulled. This
does not indicate a problem. If this occurs, point
the tool well away from yourself or any bystanders.
Release and pull the trigger again to make sure
the safety systems are in working order.
ASSEMBLY
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger and the battery cartridge is removed
before carrying out any work on the stapler.
Staples
Handle the staples and their box carefully. If the
•
staples have been handled roughly, they may be
bent out of shape, causing poor staple feed or
jamming.
Avoid storing the staples in a very humid or hot
•
place or place exposed to direct sunlight.
CAUTION:
Do not use staples other than designated in this
•
manual or staples that appear to be damaged,
bent, rusty or corroded.
Do not insert staples of which size is different each
•
other at the same time inside the magazine ,
causing poor staple feed or jamming.

Loading staples

Remove the battery cartridge.
Press the locking lever on the rear of the sub magazine
and slide the sub magazine backward.
014792
Load staples into the main magazine with their feet
facing up. Slide the sub-magazine forward.
6
1. Sub magazine
1
2. Locking lever
2