Clarke American Sanders 1600 Manuel De L'utilisateur page 18

Figure 7
Figure 8
Page -18 -
HOW TO PREPARE THE MACHINE FOR
OPERATION
How to Install the Dust Control Skirt
To install the skirt, follow this procedure:
1. Wrap the skirt around the bumper such that the
draw string can be inserted into the recess of the
bumper. See figure 7.
2. Orient the brush fastening strap at the rear of the
machine to prevent scratching surfaces.
3. Tighten and tie the string on the skirt into a bow knot
so it can later be untied for removal of the skirt.
4. Twist the ends of the string (see figure 7) and insert
them into the recess of the bumper as shown in
figure 8.
NOTE: The skirt should be stored flat on the floor
either on or off of the machine.
®
Clarke American Sanders Operator's Manual - Sander 1600DC