American Standard Ovation Curve AM00843400 Manuel Du Propriétaire page 7

2
INSTALLING WALL BRACKETS
• In this step, you'll need following parts: [1] x8, [2] x8, [3] x1, [4] x1, [23] x4, [25] x1
• In this step, you'll need the following tools: B, F, N
G
N
[3]
2a. Starting with RIGHT Wall Bracket [4], remove all 4 screws from rubber Glass Catcher [23] and remove
from Wall Bracket. NOTE: Observe how lip of glass catcher goes to the outside of bracket.
2b. If using Wall Anchors [1], place into each drilled hole.
2c. Screw RIGHT Wall Bracket [4] into place using 4 supplied ST4x35 [2] Phillips Head screws.
2d. Place Glass Catchers [23] back into slots of Wall Brackets keeping lip of glass catcher to the outside of
the bracket and screw back into place.
2e. Orientation of Glass Catchers [23] should look like illustrations in 2e & 2f.
2f. Perform same procedure for LEFT Wall Bracket [3] on opposite side.
2a
F
N
2c
[4]
[2]
Screw
ST4x35
F
2f
[4]
2b
[1]
B
2d
F
[23]
2e