American Standard Ovation Curve AM00843400 Manuel Du Propriétaire page 16

POST INSTALLATION CLEAN-UP
Remove all construction debris from bath. Tile grout can be removed with a wooden popsicle stick
or tongue depressor.
Do not use wire brushes or any other metal implement on bath surface. Post installation clean-up generally
can be completed using warm water and liquid dishwashing detergent. Stubborn dirt or stains may be
removed using granular Spic and Span mixed with water.
®
Painter's naphtha can be used to remove excess adhesives and/or wet oil-base paint.
AFTERCARE AND CLEANING
Two primary materials are used to manufacture your new American Standard shower enclosure: tempered glass
and anodized aluminum. To assure a long lasting finish on the enclosure, wipe it down with a towel after each
use.
For occasional, more concentrated cleaning efforts Lysol Non-Abrasive Bathroom Cleaner works extremely well.
Be sure that any over spray falling on the aluminum frame is rinsed thoroughly and dried. Many over-the-counter
cleaners, if applied to the aluminum and left on, will harm the metal finish and cause permanent damage even
though their directions indicate safe use on shower doors. Never use a scouring agent to clean the aluminum.
Spic And Span® Is A Registered Trademark Of The Spic And Span Company