American Standard Ovation Curve AM00843400 Manuel Du Propriétaire page 13

8
ADJUSTING EXTERIOR AND INTERIOR DOOR PANELS
• In this step, you'll need following parts: [6] x2, [10] x2
• In this step, you'll need the following tool: D
8a
8a. Once all assembly is completed, it may be necessary to adjust both the Exterior [21] and Interior [22]
Door Panels to ensure they are both level and when closed, fit up against the wall to seal properly.
(ref. Illustration)
8b. Close both Exterior and Interior Door Panels against the walls and observe if there are any gaps or open
areas where water can come out. (ref. Illustration) If there are gaps, it will be necessary to adjust the
Exterior or Interior Wheels for a proper fit at that location.
8c. Depending upon which door or doors need to be adjusted, loosen the metal nut on either Exterior or Inte-
rior Wheel using the supplied Wrench [7]. Using an adjustable Wrench, rotate the plastic nut left or right
while observing the door position as the plastic nut is turned which makes the door panels move up or
down at that location. Once fit of doors is correct for both doors, tighten any loose nuts securely.
8d. Once all adjustments are made and both door panels are correctly in place, attach both Interior Wheel
Caps [10] and Exterior Roller Caps [6] and press to fit.
VIEW FROM
INSIDE
[7]
D
MAX
8d
[6]
[10]
[7]
D
MIN
8d