Laerdal SimJunior Manuel D'instructions page 13

Changing the Pupils
SimJunior is delivered with normal pupils installed in the eyes. A
separate kit containing plastic pupil inserts (constricted and dilated)
comes with SimJunior.
To change the pupils:
1. Carefully open the eyelids wide, taking care not to tear the
Simulator face skin.
2. Using the suction cup tool provided in the kit or with the edge of
your fingernail, carefully remove the pupil from the eye.
3. Replace the pupil with the desired insert, using the suction cup
tool or by gently pressing in place.
Simulator Setup
Using an External Compressor
The external compressor connects to the clear tube found in the
cable bundle exiting the right side of the Simulator. When using an
external compressor you can turn off the internal compressor from
SimPad or LLEAP.
For more information on external compressors and regulator panels
compatible with SimJunior, contact your local Laerdal representative.
Turning on or off the internal compressor in SimPad
1. Start <Manual Mode>, select a theme and start the session.
1. Select <Miscellaneous> from the bottom menu.
2. Select <Compressor> from the sub-menu.
3. Make the desired changes in the dialog and click OK.
Turning on or off the internal compressor in LLEAP
1. Select <Tools> from the menu.
2. Select <Simulator Setup> from the Tools-menu.
3. Select <Internal compressor> from the sub-menu.
4. Make the desired changes in the dialog and click OK.
11