PRO-POINT 8844243 Manuel D'utilisation page 11

V1.0
INSTALL THE GRINDING DIE
1. Insert the 14 mm wrench (#25) onto the spindle (#22) flats to
prevent it from moving.
2. Insert the 19 mm wrench (#26) over the collet nut (#24) flats.
3. Turn the 19 mm wrench clockwise to loosen the collet nut while
holding the 14 mm spanner in place.
4. Loosen the collet nut, but do not remove. This allows the collet's
arms to spread apart.
4.1 Remove the collet nut if replacing the collet (#23) as well.
5. Insert the grinder die shaft into the collet. Make sure it is fully seated.
6. Hand-tighten the collet nut, then finish tightening with the wrenches.
OPERATION
1. Clean the die grinder of packing grease before first use. Also grease
the spindle gears. See the Air Tool Lubrication section for instructions.
2. Install the grinding die (See Assembly & Installation). The type of
grinding die installed will depend on the material and task.
3. Connect the tool to the air source.
4. Set the compressor to the correct air pressure and flow (see
Specifications). Start the compressor.
5. Push the trigger lever safety (D) forward to free the trigger lever (E).
6. Rotate the air regulator (F) wheel to adjust the grinder's speed.
7. Wait until the grinding die has reach full speed before applying it to
the material
8. Test the tool under no load to confirm the grinding die is installed
correctly.
9. Apply the grinding die against the material so the debris is moved
away from the work area. Do not press down too hard, as this can
cause the die to slow or gouge the workpiece.
10. Lift the die grinder from the material and slowly release the trigger
lever. The trigger lever safety will automatically snap back into place.
11. Wait for the grinding die to stop before placing the tool down.
12. Shut the compressor off once the task is completed. Squeeze the
trigger to release residual compressed air from the hose and tool.
Disconnect the tool.
Visit www.princessauto.com for more information
Low-Noise Air Die Grinder 8844243
11