Gunrest Side Tube; Right Gunrest Pivot; Gunrest Bar - Summit Treestands Watchtower Mode D'emploi

2 1/2" BOLTS, WASHER,
11
LOCK NUTS
GUNREST
SIDE TUBE
(PN 82073.R50)
NYLON
WASHER
1 1/2" BOLTS, WASHER,
LOCK NUTS
12
NYLON
WASHER
RIGHT
GUNREST
PIVOT
(PN 82073R65-R)
BASE PLATE
LEG BASE PLATE
(PN 82073.600)
15
ANGLED END
FACING OUT /
BOLT HOLE TO
THE INSIDE
UPPER LEG with HAND HOLD
(PN 82073.310)
SEAT ASSEMBLY (continued)
16. Attach the Gunrest Side Tubes next. Line up the front and rear
holes. Use one Nylon Washer
bolt and lock nut at each joint as shown in figure 11. Do not Over
tighten.
17. Repeat Step 16 for the other side.
18. Position the Right Gunrest Pivot as shown in figure 12. Use one
Nylon Washer between the joint. Secure with one
lock nut. Do not Over tighten.
19. Repeat Step 18 for the other side.
20. Slide the Gunrest Bar onto both Gunrest Pivots as shown in
figure 13. Line up the holes and use the
The Gunrest Bar can be adjusted using these pins.
21. Ensure all bolts from Pages 3 - 5 are securely fastened
but not so tight as to prevent the seat assembly from
pivoting.
1/4" WIRE LOCK PINS
Hardware Needed
5/16"-18 - 1 3/4" Bolt
5/16"-18 - Lock Nut
1. Position the Leg Base Plate and the Upper Leg as shown in figure
15. Notice that the angled end of the Ladder Assembly faces out and
the bolt hole is on the inside.
2. Slide the Upper Leg into the Base Plate and use one
to secure as shown in figure 16. Leave this bolt hand
and lock nut
tight for now.
1 3/4" BOLT, LOCK NUT,
HAND TIGHT
16
between both joints. Use one
1 1/2" bolt and
Wire Lock Pins

GUNREST BAR

(PN 82073.R60)
- 3
- 3
2 1/2"
to secure.
14
1 3/4" bolt
PG 7