Summit Treestands Watchtower Mode D'emploi page 15

16' LOWER LEG ASSEMBLY
Hardware Needed
5/16"-18 - 2 3/4" Bolt - 9
5/16"-18 - Lock Nuts - 9
1. Position a Coupler Plate and a 72" Leg Assembly as
shown in figure 56. The oval pre-punched holes MUST be
on the far end of the 72" Leg Assembly.
2. Line up a Bracket with the upper bolt hole on the inside
of the Coupler Plate as shown in figure 57. The Bracket
must attach as before - horizontal to the ground when the
Tripod is standing.
3. Use two 2 3/4" bolts with lock nuts
Plate, Bracket and 72" Leg Assembly.
57
BRACKET
(PN 82073.1300)
2 3/4" BOLTS, LOCK NUTS -
WRENCH TIGHTEN
4. Repeat Steps 1 - 3 for the opposite Leg. See figure 58.
5. Locate the pre-punched hole a little further than half-
way down the Leg Assembly.
6. Position one Bracket over this hole from the inside and
secure using one 2 3/4" bolt and lock nut
59. You must run this bolt from the inside out so that
the head of the bolt is sitting on the Bracket when tight.
As before, the Bracket should run horizontal to the ground
when the tripod is standing up.
7. Repeat for the other Leg Assembly. Use one
and lock nut to secure these Brackets. You must run this
bolt from the inside out so that the head of the bolt is
sitting on the Bracket when tight.
1/4"-20 - 1 1/2" Bolt - 18
1/4"-20 - Lock Nuts - 18
to secure the Coupler
as shown in figure
2 3/4" bolt
56
2 3/4" BOLTS, LOCK NUTS -
58
WRENCH TIGHTEN
BRACKET
(PN 82073.1300)
72" LEG
ASSEMBLY
(PN 82073.1200)
59
BRACKET
(PN 82073.1300)
2 3/4" BOLTS, LOCK NUTS -
WRENCH TIGHTEN
BRACKET
(PN 82073.1300)
COUPLER PLATE
(PN 82073.1000)
72" LEG
ASSEMBLY
(PN 82073.1200)
Oval hole must be
on far end of leg
assembly
COUPLER PLATE
(PN 82073.1000)
PG 15