Leg Assembly - Summit Treestands Watchtower Mode D'emploi

42
Oval hole must be
on far end of leg
assembly
12' UPPER LEG BRACES
1. Locate the pre-punched hole half-way down the Leg Assembly.
2. Position one Bracket over this hole from the inside and secure
using one 2 3/4" bolt and lock nut
before, the Bracket should run horizontal to the ground when the
tripod is standing up - You must run this bolt from the inside
out so that the head of the bolt is sitting on the Bracket when
tight.
3. Repeat for the other Leg Assembly and the Ladder Assembly
as shown in figure 45. Use one
each Bracket. You must run these bolts from the inside out so
that the head of the bolt is sitting on the Bracket when tight.
2 3/4" BOLTS, LOCK NUTS,
WRENCH TIGHTEN
45
PG 12

72"LEG ASSEMBLY

(PN 82073.1200)
as shown in figure 44. As
2 3/4" bolt and lock nut to secure
BRACKET
(PN 82073.1300)
BRACKET
(PN 82073.1300)
LEG ASSEMBLY (continued)
10. Position one of the 72" Leg Assemblies as shown in figure 42.
The oval pre-punched holes MUST be on the far end of the Leg
Assembly. These holes are for the Spikes included with this tripod
11. Slide the Leg Assembly into the Coupler Plate and secure using
one 2 3/4" bolt and lock nut
12. Rotate the tripod again and repeat Steps 7 - 11 for the other
Leg Assembly.
2 3/4" BOLT, LOCK NUT,
WRENCH TIGHTEN
43
44
BRACKET
(PN 82073.1300)
as shown in figure 43.
2 3/4" BOLT, LOCK NUT,
WRENCH TIGHTEN
BRACKET
(PN 82073.1300)