Gunrest Upright; Seat Side Tube - Summit Treestands Watchtower Mode D'emploi

5
6
SEAT SIDE
TUBE
(PN 82073.R10)
12. Insert two Nylon Bushings
Seat Back as shown in figure 8.
13. Pivot the Seat Back up into the bracket on the Seat Side Tube.
Use a Nylon Washer between the Seat Side Tube and the Slide
Bracket as shown in figure 9.
14. Rotate the Slide Bracket down and line up the hole. Insert one
2" bolt with one Steel Slide Bushing
in the Slide Bracket and Side Tube and secure with a
figure 9 and 10. Do not Over tighten.
15. Repeat Steps 12 - 13 for the other side.
2" BOLT, STEEL SLIDE
BUSHING, WASHER
9
NYLON
WASHER
SLIDE
BUSHING
(PN SU10627)
PG 6
GUNREST
UPRIGHT
(PN 82073.R40)
into the pre-punched holes into the
(shown in red) through the hole
lock
SEAT ASSEMBLY (continued)
8. Slide one Gunrest Upright down onto the Footrest Bar as shown
in figure 5.
9. Next, line up one of the Seat Side Tubes between the Seat Back
and Footrest Bar as shown in figure 6. The Seat Side Tube attaches
over the Gunrest Upright and between the Slide Bracket and Seat
Back.
10. Use one 1 3/4" bolt and lock nut
figure 7. Do not Over tighten.
11. Repeat Steps 8 - 10 for the other side.
7
8
NYLON
BUSHING
nut. See (PN SU10640)
10
RIGHT SIDE
LEFT SIDE
to secure at the front. See
1 3/4" BOLT, LOCK NUT
LOCK NUT
www.summitstands.com