Summit Treestands Watchtower Mode D'emploi page 14

12' LEG BRACES (continued)
8. Walk around to the opposite side of the Tripod.
Attach one more Upper Cross Brace
OUTSIDE of the Bracket and one more Cross Brace
(in blue) to the INSIDE of the Bracket. See figure 52.
Figure 53 shows the correct placement of braces. Each
Upper Cross Brace should alternate - with the
Braces always bolting to the outside of the bracket and
the Blue Braces always bolting to the inside.
9. Use
1 1/2" bolts and lock nuts
point.
53
OUTSIDE
10. Rotate the tripod so that you can bolt up the last
two Upper Cross Braces. These Braces attach the same
way. See figure 54. The Upper Cross Brace
attaches to the outside of the Bracket while the Cross
Brace (in blue) attaches to the inside of the Bracket.
Use 1 1/2" bolts and lock nuts
point.
11. The finished Leg Brace setup should look like
figure 55. Note that the green
on the outside and the blue
the inside.
55
PG 14
(in green) to the
Green
at each connection
BRACKET
(PN 82073.1300)
INSIDE
(in green)
at each connection
Upper Cross Braces are
Upper Cross Braces are on
52
54
The tripod can be used as a 12' model by not
installing the Lower Legs and Lower Leg Braces.
Before doing this YOU MUST read and folllow the
Setup instructions on Page 18. The ground stakes
supplied MUST BE USED.
NOTICE