Tools Required; Seat Assembly; Seat Base; Footrest Bar - Summit Treestands Watchtower Mode D'emploi

4

TOOLS REQUIRED

Tools
• 7/16" Wrenches and / or Socket / Ratchet
• 1/2" Wrenches and / or Socket / Ratchet
- Assembly can be made easier by the use of a powered ratchet or drill with socket adapter (take care not to Over tighten when using power tools to
assemble)
- Due to the large size of these tripods, it is mandatory that four people initially setup the tripod.
- Assemble entire product before fully tightening any bolts / locknuts.
DO NOT OVER-TIGHTEN the bolts and nuts to the point that the tubing becomes deformed or bent.
5
ASSEMBLY

SEAT ASSEMBLY

SEAT BASE

(PN 82073.R20)

FOOTREST BAR

(PN 82073.R30)
5. Position the Seat Back as shown in figure 3.
6. Insert two Nylon Bushings
holes on each side of the Seat Back as shown in
figure 3.
7. Slide the Seat Back into the brackets on the Seat
Base. Attach on both sides using one
and lock nut per side as shown in figure 4. Do not
over tighten.
3

SEAT BACK

(PN 82073.R30)
1
NYLON
BUSHING
(PN SU10640)
into the pre-punched
1 3/4" bolt
NYLON
BUSHING
(PN SU10640)
Hardware Needed
1/4"-20 - 1 1/2" Bolt
1/4"-20 - 1 3/4" Bolt
1/4"-20 - 2" Bolt
1/4"-20 - 2 1/2" Bolt
ASSEMBLE AND INSTALL ON LEVEL GROUND ONLY!
1. Position the Seat Base and Footrest Bar as shown in figure 1.
2. Insert two Nylon Bushings
of the Footrest Bar as shown in figure 1.
3. Slide the Footrest Bar into the brackets on the Seat Base. Insert one
2" bolt from the inside out as shown in figure 2. Slide on one
Washer and then one of the Slide Brackets followed by a
Notice the position of the cutout on the Slide Bracket. Do not over
tighten as this connection is designed to pivot. See figure 2.
4. Repeat Step 3 for the other side.
2
SLIDE
BRACKET
(PN 82073.R70)
4
1/4"-20 - Lock Nut
- 2 Wire Lock Pins
- 4 Nylon Bushings
- 4 Nylon Washers
- 4 Steel Slide Bushings
into the pre-punched holes on each side
2" BOLT, WASHER, LOCK
NUT
1 3/4" BOLTS, LOCK NUTS
- 14
- 2
- 12
- 10
- 2
Nylon
lock nut.
PG 5