Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ANGLED END
FACING OUT /
BOLT HOLE TO
THE INSIDE
UPPER LEG
(PN 82073.300)
SEAT SWIVEL
Hardware Needed
1/4"-20 - 1" Bolt
1/4"-20 - Lock Nut
19
PLATFORM ASSEMBLY
Hardware Needed
5/16"-18 - 3 3/4" Bolt
5/16"-18 - Lock Nut
3 3/4" BOLTS,
21
HAND TIGHT
PG 8
17
UPPER LEG
(PN 82073.300)
- 4
Steel Washers
- 4
1/4" Nylon Spacer
1" BOLT
(PN SU10624)
STEEL WASHER
(PN SU10625)
SEAT SWIVEL
(PN 82073.700)
1/4" NYLON
SPACER
(PN SU10642)
LEG BASE
PLATE
LOCK NUT
(PN SU10612)
- 9
- 9
PLATFORM
SECTION
(PN 82073.400)
BASE PLATE (continued)
3. Position the two Upper Legs as shown in figure 17. Slide these
legs into the Base Plate and secure with one
per Leg (see figure 18). Leave these bolts hand tight for now.
1 3/4" BOLTS, LOCK NUTS,
HAND TIGHT
18
- 4
- 4
1. Carefully stand the tripod assembly up. The Seat Swivel
bolts to the Leg Base Plate from the top. Pivot the swivel so
that you have access to the bolt holes.
2. Line up the pivot with the 4 pre-punched holes in the
Leg Base Plate.
3. The correct order for attaching the swivel is:
washer,
Swivel Plate,
Nut.
See figure 19 and 20. Leave all bolts hand tight until
they are started and then wrench tighten. All hardware for
the Seat Swivel will be
20
1. Position one of the Platform Sections as shown in figure 21. The
expanded metal side will face up. Line up the section with the bolt
holes near the middle of the Leg Sections and insert one
in each hole.
2. Attach another Platform Section next. Slip it over the exposed
bolt from Step 1 and use one
tight for now. Use one more
figure 22.
22
1 3/4" bolt and lock nut
1/4" Nylon Spacer,
Leg Base
1/4"-20
thread.
lock nut
to secure. Leave this hand
3 3/4" bolt
on the opposite side. See
LOCK NUT
3 3/4" BOLT,
HAND TIGHT
PLATFORM
SECTION
(PN 82073.400)
1" Bolt,
Plate, Lock
3 3/4" bolt
Publicité
Table des Matières
