Summit Treestands Watchtower Mode D'emploi page 17

16' LOWER CROSS BRACE ATTACHMENT
The six Lower Cross Braces will be attached next.
These Lower Cross Braces attach in the same
manner as the Upper Cross Braces. In the
instruction diagrams, Green
outside of the Brackets and
the inside.
! CAUTION
Brace attachment must be completed BEFORE
attempting to stand the Tripod up.
1. Start by positioning two Lower Cross Braces
as shown in figure 65. The
to the OUTSIDE of the two Brackets and the
Brace will bolt to the INSIDE.
2. Use 1 1/2" bolts and lock nuts
secure the Braces.
3. Due to the size of the Tripod base, you will have
to rotate it in order to attach the next set of braces.
4. Attach two more Lower Cross Braces as shown
in figure 66. Use 1 1/2" bolts and lock nuts
Bracket to secure the Braces
5. Rotate the Tripod one more time and attach the
last two Lower Cross Braces as shown in figure 67.
Use 1 1/2" bolts and lock nuts
secure the Braces.
6. The finished Lower Cross Brace setup should look
like figure 68. Note that the
Braces are on the outside and the
Braces are on the inside.
68
Braces attach to the
Blue Braces attach to
Green Brace will bolt
Blue
at each Bracket to
at each
at each Bracket to
green Lower Cross
blue Lower Cross
65
LOWER
CROSS
BRACE
1 1/2" BOLTS, LOCK NUTS -
WRENCH TIGHTEN
66
LOWER
CROSS
BRACE
1 1/2" BOLTS, LOCK NUTS -
WRENCH TIGHTEN
67
LOWER
CROSS
BRACE
LOWER
CROSS
BRACE
LOWER
CROSS
BRACE
LOWER
CROSS
BRACE
1 1/2" BOLTS, LOCK NUTS -
WRENCH TIGHTEN
PG 17