Westfalia 87 39 54 Mode D'emploi page 18

resuming the cut. Otherwise the disc may jam, jump out of the
cut or kick back.
 Support sheets or large work pieces to reduce the risk of a
kickback caused by the disc being wedged in the work piece.
Larger work pieces may deform under their own weight. The
work piece must be supported on both sides, on the edges as
well as close to the cut.
 Be especially careful when undertaking "pocket cuts" in
existing walls or other areas which cannot be overlooked.
When plunging into the wall the disc can kick back when
hitting gas or water pipes, wires or other objects in the wall.
 Make sure the cord cannot get caught in any way. Do not
wind the cord around the electric tool and do not bend it. Do
not jam the cord or pull cord around edges. Do not pinch the
power cord in any way and keep it away from hot and sharp
surfaces.
 Before cleaning or maintaining, first disconnect the plug from
power mains.
 Do not continue using the electric tool if it was damaged or
the tool was dropped or immersed in water. Please contact
our customer support service.
Safety Notes
14