Parkside PKLL 8 A2 Traduction Des Instructions D'origine page 34

6. For a horizontal alignment of the tripod flat head
long handle
or down as desired. If the air bubble of the spirit level
exactly in the middle of the circle, the tripod flat head is aligned
horizontally. Then, tighten the long handle
7. If necessary, loosen the locking screw
head up to 360 degree horizontally to get desired side. Once
18
reached the desired side, tighten the locking screw
8. If necessary, loosen the locking screw
tripod flat head
Once reached the desired angle, tighten the locking screw
Securing the Cross Line Laser
Align 1/4"-thread
the quick shoe and make sure to tighten the screw well by screwing
the metal key
9
the quick shoe
19
Removing quick shoe from tripod:
If necessary to move the cross line laser to another location (or) would
like to store the cross line laser separately, it is always not necessary to
unscrew the cross line laser from tripod. User can just remove the cross
line laser together with quick shoe
steps:
1. Pull the lever
2. Remove the quick shoe
3. Fold-up the metal key
make sure that the cross line laser is firmly screwed onto the quick
shoe. Now the cross line laser is easy to move out separately from
tripod.
34 GB/IE
by turning anti-clockwise and move the handle up
12
up to 90 degree vertically to get desired angle.
18
of cross line laser with the 1/4"-screw
6
clockwise. The metal key
.
on the tripod flat head
1 1a
.
19
on the bottom side of the quick shoe and
9
by turning it clockwise.
12
to rotate the tripod flat
13
to adjust the angle of the
10
is on the bottom side of
9
from tripod by following below
19
along the side.
18
, loosen the
18
is located
11
.
13
.
10
of
8