Publicité
Les langues disponibles
Les langues disponibles
Working without the automatic
levelling system
Put the LOCK switch
Hold down the H-button
on. Now the product will release two laser lines from the laser
beam opening
levelling will always be indicated via the red LED indicator
Practical guidance
Always use only the middle of the laser line for markings. The width
of the line depends on the distance.
Working with the tripod
Setup and alignment
1. Pull all the three legs
which is connecting all the three cross hinges will be moved to the
end of the middle column.
2. Release the blocking levers
your desired height.
3. Then, fold-back all those blocking levers
4. Check the straight positioning by using the bubble level
tripod is straight, the air bubble will be positioned in the centre of
the circle. If necessary, readjust the length of the legs
5. If additional height is necessary, loosen the locking screw
extend the centre column to desired height. Once reached the
desired height, tighten the locking screw
into the position .
3
until the red LED indicator
1
that are not levelled. Operation without automatic
7
of the tripod apart. The plastic ring
17
and extend the legs until you get
16
2
.
16
11
.
17
.
14
comes
.
2
,
15
. If the
and
14
GB/IE
33
Publicité
