Publicité
Les langues disponibles
Les langues disponibles
R TEX
Check that the insertion tool being used has the
♦
correct shank dimension.
Check that the pneumatic machine is getting the
♦
correct amount of lubricant. Too much lubrication
can cause starting problems, low power or uneven
performance.
Check that the compressed air system supplies
♦
the machine with sufficient air pressure to give full
power.
Check that the dimension and length of the air
♦
hose are according to the recommendations. See
"Installation".
If there is a risk of freezing, check that the
♦
machine's exhaust ports are not blocked.
If the machine function is still not satisfactory after
♦
this procedure, contact an authorised service
workshop.
Storage
Clean the machine properly before storage, in
●
order to avoid hazardous substances. See "Dust
and fume hazard"
Pour approximately
1
⁄
●
2
the air inlet nipple, connect the machine to the
compressed air supply and start it for a few
seconds.
●
Always store the machine in a dry place.
Disposal
A used machine must be treated and disposed of in
such a way that the greatest possible portion of the
material can be recycled and any negative influence
on the environment is kept as low as possible, and
in respect to local restrictions.
© 2015 Construction Tools PC AB | No. 9800 1724 71 | 2015-12-20
Original instructions
oz (5 cl) of oil directly into
Safety and operating instructions
21
Publicité
