Publicité
Les langues disponibles
Les langues disponibles
R TEX
NOTICE Never cool a hot insertion tool in water, it
can result in brittleness and early failure.
Selecting the right insertion tool
Selecting the right insertion tool is a precondition for
proper machine function. It is important to select
insertion tools of high quality to avoid unnecessary
machine damage.
The machine can be destroyed if you use an incorrect
insertion tool.
Recommended insertion tools are listed in the
machine's spare parts list.
Narrow chisel
Moil point
Wide bladed chisel
WARNING Vibration hazard
Using inserted tools that do not fulfil the criteria
mentioned below, will result in a longer time to
complete a task, and may result in higher levels of
vibration exposure. A worn tool will also cause
increased working time.
Make sure that the inserted tool is well-maintained,
►
not worn out and of the proper size.
►
Always use a sharp tool in order to work efficiently.
© 2015 Construction Tools PC AB | No. 9800 1724 71 | 2015-12-20
Original instructions
The narrow chisel is used for
demolition and cutting work in
concrete and other types of
hard materials.
The moil point is only used for
making holes in concrete and
other types of hard materials.
The wide bladed chisel is used
in soft materials, such as
asphalt and frozen ground.
Safety and operating instructions
Checking for wear on the tool shank
A
Use the gauge that corresponds to the insertion tool's
shank dimension. See section "Technical data" for
correct tool shank dimensions.
●
Check if the gauge's hole (A) can be pushed down
on the insertion tool's shank, this means that the
shank is worn out and the insertion tool should be
replaced.
Check length (B) according to the machine type.
●
Length (C) should exceed 120 mm, length (D)
●
should be between 55 mm and 63 mm.
B
17
Publicité
