Publicité
Les langues disponibles
Les langues disponibles
Safety and operating instructions
Fitting and removing the insertion tool
Whenever fitting or removing the insertion tool the
following instructions must be observed:
♦
To prevent an accidental start: switch off the air
supply and bleed the machine by pressing the
start and stop device. Disconnect the machine
from the power source.
♦
Before inserting a tool, lubricate the tool shank
with grease.
♦
Close the tool retainer and check the lock function
by pulling the inserted tool sharply outwards.
♦
When fitting collared insertion tool, see the
following steps:
1
2
18
When fitting notched insertion tool, see the
♦
following steps:
1
3
Operation
WARNING Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
Learn how the machine is switched off in the event
►
of an emergency.
►
Stop the machine immediately in all cases of
power supply interruption.
© 2015 Construction Tools PC AB | No. 9800 1724 71 | 2015-12-20
R TEX
2
3
Original instructions
Publicité
