Technical Specifications; Electrical Wiring - Polar Refrigeration CK640 Mode D'emploi

UK
Troubleshooting
If your POLAR appliance develops a fault, please check the following table before making a call to the Helpline
or your POLAR retailer.
Fault
The appliance is not
working
The appliance is leaking
water
The appliance is
unusually loud

Technical Specifications

Model Voltage
CK640 230v 50Hz

Electrical Wiring

POLAR appliances are supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
POLAR appliances are wired as follows:

Live wire (coloured brown) to terminal marked L

Neutral wire (coloured blue) to terminal marked N

Earth wire (coloured green/yellow) to terminal marked E
All POLAR appliances must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection
being required they must be readily accessible.
Telephone Helpline: 0845 146 2887 (United Kingdom)
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
The appliance is not properly leveled
The discharge outlet is blocked
Movement of water to the drain is
obstructed
The water container is damaged
Loose nut/screw
The appliance has not been installed in
a level or stable position
Power Current
450W 3A 3 x GN 2/3
Capacity Dimensions
H X W X D (mm)
390 x 600 x 585
Action
Check the unit is plugged in correctly
and switched on
Call POLAR agent or qualified
Technician
Replace the fuse
Check power supply
Call POLAR agent or qualified
Technician
Adjust the screw feet to level the
appliance (if applicable)
Clear the discharge outlet
Clear the floor of the appliance (if
applicable)
Call POLAR agent or qualified
Technician
Check and tighten all nuts and screws
Check installation position and
change if necessary
Weight
(Kg)
42