Polar Refrigeration CK640 Mode D'emploi page 10

UK
If the temperature measured by the pin probe reaches the chilling endpoint temperature prior to expiry of the
maximum chilling time duration:

the device will switch to storage mode

the display will show the message "End"

the buzzer will sound for the period of time set by parameter AA

press any key to mute the buzzer; press once more to cancel the message "End".

If the temperature measured by the pin probe does not reach the chilling endpoint temperature prior to expiry of
the maximum chilling time duration:

chilling will continue

the LED

the buzzer will sound

press several times to:
- mute the buzzer
- display the time elapsed since the maximum chilling time expired
- display the cabinet temperature
- display the message "nEg"
- exit the procedure, or leave for 15 seconds

when the temperature measured by the pin probe reaches the chilling endpoint temperature:
- the device will switch to storage mode
- the LED
- the display will show the message "End"
- the buzzer will sound for the period of time set by parameter AA
- press any key to mute the buzzer; press once more to cancel the message "End".
During storage:

the display shows the cabinet temperature

if chilling had a positive outcome, the LEDs
outcome, the LEDs

the parameter rA sets the operational set point

press several times to:
- display the message "nEg"
- exit the procedure, or leave for 15 seconds.
To interrupt the cycle:

press for2 seconds.
Telephone Helpline: 0845 146 2887 (United Kingdom)
will flash and the LED
will continue to flash and the LED
and will be on and the LED
will be on
will continue to stay on
and and will be on; if chilling had a negative
will flash