bosal 004-368 Instructions De Montage page 4

Draw end of bunch with brown, black/green, grey/green and grey/white leads to right standing lights:
6.
a) Disconnect 6-input side joint from standing lights and connect with suitable joint in electric bunch. Connect
remaining joint of electric bunch to standing lights.
7.
Draw remaining end of bunch with 6-input joints to left standing lights:
a) Disconnect 6-input side joint from standing lights and connect with suitable joint in electric bunch. Connect
remaining joint of electric bunch to standing lights.
8. Place 6-input joint behind left side casing in boot.
Connect additional control set in vehicles with light installation control using 6-input connection built in bunch.
This connection is not used in vehicles without light installation and bridge connection shall not be disconnected.
Additional set for electric installation control
Vehicles without reversing control system (APS):
9.
Leave red/white lead not connected in boot. Cut the end off and insulate the lead.
Red/white lead cannot touch vehicle ground.
10.
Vehicles with reversing control system (APS):
There is a bracket with plug connections in the left lower part of driver space, beside door post. Take it carefully out
of holder and disconnect 10-input plug connection. Red/white lead has already been assembled in 10-input con-
nection of cap casing in container no.3. Draw secondary blockade (pink) from end casing. Put red/white lead into
container no.3 and reassemble the blockade. Connect 10-input plug connection and assemble it on bracket. Reas-
semble bracket with plug connections beside door post.
11. Trailer power supply:
Refer to 13-pin version. 3-pin connector housing (red/blue, yellow, brown, brown/green cables) is provided for ex-
panded socket functions. Put this part of cable set behind the trim. To expand socket functions it is necessary to or-
der the following parts:
Function "current supply and earth"
Function "current supply, charge line and earth"
Secure the cable set with supplied cable ties, re-install all trims and other parts which were removed during instal-
lation.
Connect the earth lead to the battery and check all vehicle functions with connected trailer or suitable testing de-
vice.
article no. 014-199
part no. 014-169
part no. 015-069