ABB PSE18 Manuel page 9

7. Switch ON the control supply voltage, terminals 1 and 2.
8. Continue to configure parameters as described in chapter 6, Settings.
9. Switch ON the operational voltage.
There is some flexibility in the connecting of your softstarter, but fol-
lowing the steps above will enable operation of the PSE softstarter. An
example of a complete installation can be found in the graphics section.
The first one uses fuses and contactors and the second one uses a
circuit breaker.
Depending on the two phase control, a connected motor terminal
always carries live hazardous voltage. Do not touch terminals when
voltage is applied. Output terminals will have live voltage even when the
device is OFF. This can cause death or serious injury.
Softstarters Type PSE18...PSE370 User Manual short form 1SFC132369M9901 9
13